Diagnostics
12.2 FMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
907
The status of the optical ports is displayed.
Commands in the Interface Configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the Interface configuration mode with the
end command, you return to the
Privileged EXEC mode.
With this command, you enable fiber monitoring.
● To be able to use the fiber monitoring function, enable LLDP. The fiber monitoring
information is appended to the LLDP packets.
● You can only use fiber monitoring with transceivers capable of diagnostics. Note the
documentation of the devices.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Call the command without parameter assignment:
fmp
Default: enabled
Fiber monitoring is enabled.
To Next Page
Loading...
Need help?
General