EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #764 background imageLoading...
Page #764 background image
Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
764 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The device is a static rendezvous point.
Further notes
You delete the configuration with the no ip pim static-rp command.
You specify the interfaces for static rendezvous points with the
rp-static rp-address
command.
You display the static rendezvous points with the
show ip pim rp-static command.
9.10.3.5
no ip pim static-rp
Description
With this command, you delete the configuration of the device as a static rendezvous point.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ip pim static-rp
Result
The device is not a static rendezvous point.
Further notes
You configure the device as a rendezvous point with the ip pim static-rp command.
You specify the interfaces for static rendezvous points with the
rp-static rp-address
command.
You display the static rendezvous points with the
show ip pim rp-static command.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals