Siemens SCALANCE XM-400 - No Ipv6 Ospf Hello-Interval

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
606 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf hello-interval <interval>
The parameter has the following meaning:
Parameter
Description
Range of values / note
interval
Interval in seconds 1 ... 65535
Default: 10
The routers located on the same link must have the
same interval.
Result
The interval is specified.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You reset the interval to the default with the
no ipv6 ospf hello-interval command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.6
no ipv6 ospf hello-interval
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.