Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.8 MLD Snooping (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
508 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global configuration mode or in the VLAN configuration mode.
The command prompt is in the Global configuration mode is:
cli(config)#
or in the VLAN configuration mode:
cli(config-vlan-$$$)#
Syntax
Call the command without parameter assignment:
no ipv6 mld snooping
Result
MLD snooping is disabled.
Further notes
You enable MLD snooping with the ipv6 mld snooping command.
8.8.3.3
ipv6 mld snooping querier
Description
With this command, you configure the MLD snooping on the device as querier for a specific
VLAN.
Requirement
● The VLANs on the device are enabled.
● You are in the VLAN configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call the command without parameters:
ipv6 mld snooping querier
Result
MLD snooping is configured as querier.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English