Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.10 PIM (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
757
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ip pim rp-set [rp-address]
The parameter has the following meaning:
Parameter
Description
Range of values / note
rp-address
IP address of the interface
-
Result
The multicast groups with rendezvous points belonging to them are displayed.
Further notes
You define interfaces as candidates for rendezvous points with the command rp-candidate
rp-address
.
You configure a device as a static rendezvous point with the
ip pim static-rp command.
You specify the interfaces for static rendezvous points with the
rp-static rp-address
command.
9.10.1.6
show ip pim bsr
Description
With this command, you display information on the selected bootstrap router (BSR).
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameter assignment:
show ip pim bsr

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English