Siemens SCALANCE XM-400 - Send Test Mail; Smtp-Port

Network protocols
7.9 SMTP Client
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
418 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The e-mail name of the sender is reset.
Further notes
You configure the e-mail name of the sender with the sender mail-address.
You display the setting with the
show events sender email command.
7.9.2.5
send test mail
Description
With this command, you send an e-mail according to the currently configured SMTP settings.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call the command without parameters:
send test mail
Result
An e-mail according to the currently configured SMTP settings is sent.
Further notes
You can display the current SMTP settings with the show events smtp-server command.
7.9.2.6
smtp-port
Description
With this command, you configure an SMTP port.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#