Siemens SCALANCE XM-400 - Redistribute

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
702 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no distribute-list route-map <name(20)> {in | out}
The parameters have the following meaning:
Parameter
Description
Range of values / note
name
Name of the routing table.
Maximum of 20 characters.
in
The filtering for incoming routing infor-
mation is disabled.
-
out
The filtering for outgoing routing infor-
mation is disabled.
-
Result
The filtering is disabled.
9.7.3.7
redistribute
Description
With this command you specify which route information is forwarded by RIP.
Note
This command is available only with layer 3.
Requirement
You are in the RIP router configuration mode.
The command prompt is as follows:
cli(config-ripng)#
Syntax
Call up the command with the following parameters:
redistribute {static|connected|ospf} metric <integer(0-16)> [route-map <name(20)>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
default
Default routes are distributed.
-
connected
Route information of local subnets (IP
interfaces) is distributed for which RIP
is not configured.
-