Siemens SCALANCE XM-400 - No Ip Nat Pool; Ip Nat Service

Layer 3 functions
9.9 NAT (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
746 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.9.3.6
no ip nat pool
Description
With this command, you delete a pool for dynamic address translations.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
no ip nat pool <inside global ip>
The parameter has the following meaning:
Parameter
Description
Range of values / note
inside global ip
Start address for the dynamic assign-
ment of addresses at which devices
are reachable from external.
Enter a valid IPv4 address.
Result
A pool is deleted.
Further notes
You configure a dynamic address translation with the ip nat pool command.
You display the current configuration with the
show ip nat command.
9.9.3.7
ip nat service
Description
With this command you configure static port translations (NAPT) for an interface with a
service.
Requirement
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#