Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
610 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.3.4.10
no ipv6 ospf passive-interface
Description
With this command, you enable the OSPFv3 interface.
Note
This command is available
only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf passive-interface
Result
The OSPFv3 interface "" is enabled.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You deactivate the OSPFv3 interface with the
ipv6 ospf passive-interface command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.11
ipv6 ospf priority
Description
With this command, you specify the router priority. The designated router is identified based
on the priority.
Note
This command is available only with layer 3.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English