To Next Page

To Previous Page

Layer 3 functions

9.2 OSPFv2 (IPv4)

SCALANCE XM-400/XR-500 Command Line Interface (CLI)

Configuration Manual, 06/2016, C79000-G8976-C252-11

551

Result

The address range is deleted.

Further notes

You configure the address range with the summary-address command.

9.2.4

Commands in the Interface Configuration mode

This section describes commands that you can call up in the interface configuration mode.

Depending on the Interface selected, various command sets are available.

In the Global configuration mode, enter the

interface command to change to this mode.

Commands relating to other topics that can be called in the interface configuration mode can

be found in the relevant sections.

● If you exit the Interface configuration mode with the

exit command, you return to the

Global configuration mode.

● If you exit the Interface configuration mode with the

end command, you return to the

Privileged EXEC mode.

9.2.4.1

ip ospf authentication

Description

With this command, you specify the type of authentication. The following methods are

possible:

● Authentication using an unencrypted password.

● Authentication using MD5

Note

This command is available only with layer 3.

Requirement

● The interface is an IP interface.

● Authentication using MD5: A password and a key ID are created.

● Authentication using an unencrypted password: A password is created.

● You are in the Interface configuration mode.

The command prompt is as follows:

cli(config-if-$$$)#

Siemens SCALANCE XM-400 Configuration Manual

Other manuals for Siemens SCALANCE XM-400