Siemens SCALANCE XM-400 - Private-Vlan Mapping

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
201
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no map subnet <ip-subnet-address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
ip-subnet-address
IPv4 subnet address
Enter a valid subnet address
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IPv4 subnet was removed.
Further notes
You configure the setting with the map subnet command.
You can display the status of this function and other information with the
show subnet-vlan
mapping
command.
6.1.3.3
private-vlan mapping
Description
With this command you specify from which secondary PVLANs the IP interface of the
primary PVLAN will be reachable.
Requirement
● The interface is configured as an IP interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#