Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.2 IGMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
455
8.2.3.18
no ip igmp static-group
Description
With this command, you delete the assignment of a client to a static multicast group..
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#
Syntax
Call up the command with the following parameters:
no ip igmp static-group <Group Address> [source <Source Address>]
The parameters have the following meaning:
Parameter
Description
Range of values / note
Group Address
Address of the multicast group
-
source
Keyword for a client
-
Source Address
IP address of the client
-
Result
The client is deleted from the multicast group.
Further notes
You assign a client to a multicast group with the ip igmp static-group command.
You display the list of configured multicast groups with the
show ip igmp group-list
command.
8.2.3.19
ip igmp version
Description
This command specifies which version of IGMP will be used on an interface..
Requirement
You are in the Interface Configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English