Siemens SCALANCE XM-400 - No Host

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
594 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You remove an entry with the no host command.
You display the host table with the
show ipv6 ospf host command.
9.3.3.13
no host
Description
With this command, you remove an entry in the host table.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no host <IPv6-Address>
The parameter has the following meaning:
Parameter
Description
Range of values / note
IPv6-Address
IPv6 address of
the host
Enter a valid IPv6 address
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The entry has been removed
Further notes
You create an entry with the host command.
You display the host table with the
show ipv6 ospf host command.