EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #613 background imageLoading...
Page #613 background image
Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
613
Syntax
Call up the command with the following parameters:
ip ospf retransmit-interval <interval>
The parameter has the following meaning:
Parameter
Description
Range of values / note
interval
Interval in seconds 1 ... 1800
Default: 5
Result
The interval is specified.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You reset the interval to the default with the
no ipv6 ospf retransmit-interval command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.14
no ipv6 ospf retransmit-interval
Description
With this command, you reset the interval to the default value.
Note
This command is available only with layer 3.
Requirement
The interface is an IPv6 interface.
You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call the command without parameter assignment:
no ipv6 ospf retransmit-interval

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals