Siemens SCALANCE XM-400 - No Ip Ospf Authentication-Key; Ip Ospf Cost

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
554 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.2.4.4
no ip ospf authentication-key
Description
With this command, you delete the password.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf authentication-key
Result
The password is deleted.
Further notes
You configure the password with the ip ospf authentication-key command.
9.2.4.5
ip ospf cost
Description
With this command, you specify the costs for the OSPF interface.
Note
This command is available only with layer 3.