Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
565
The parameter has the following meaning:
Parameter
Description
Range of values / note
Value
Priority 0 ... 255
Default: 1
Result
The priority is specified.
Further notes
You can reset the priority to the default with the no ip ospf priority command.
You display the router ID and other information with the
show ip ospf interface command.
9.2.4.18
no ip ospf priority
Description
With this command, you reset the value for the priority to the default value.
Note
This command is available onl
y with layer 3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if)#
Syntax
Call the command without parameter assignment:
no ip ospf priority
Result
The value for the priority is reset to the default.
Further notes
You configure the priority with the ip ospf priority command.
You display the router ID and other information with the
show ip ospf interface command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English