Siemens SCALANCE XM-400 - Clear Spanning-Tree Counters; Commands in the Global Configuration Mode

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
244 Configuration Manual, 06/2016, C79000-G8976-C252-11
If you do not select any parameters from the parameter list, the process is restarted for all
interfaces.
Result
The connection settings for spanning tree are renegotiated.
6.3.3
clear spanning-tree counters
Description
With this command, you reset all the statistical counters of the spanning tree function at the
device and port level.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call the command without parameters:
clear spanning-tree counters
Result
The spanning tree counters are reset.
6.3.4
Commands in the global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.