Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
580 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You change the type of the area with the no area command.
You can display the status of this function and other information with the
show ipv6 ospf
areas
command.
You display the content of the database with the
show ipv6 ospf ... database ...
command.
9.3.3.2
no area
Description
With this command, you remove or change an area. To remove an area, there must be no
IPv6 interface connected to it.
Note
This command is available only with layer 3.
Requirement
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no area <area-id>
[ {
stub | nssa | virtual-link <router-id> |default-metric |
{range {summary | Type7} | summary-prefix}
<IPv6-Prefix> <Prefix-Length>
} ]
The parameters have the following meaning:
Parameter
Description
Range of values / note
area-id
Area ID Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
The area ID 0.0.0.0 is reserved for the backbone area and cannot be
deleted.
stub
Stub area
-
nssa
NSSA
-

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English