Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
636 Configuration Manual, 06/2016, C79000-G8976-C252-11
vrrp primary-ip
Description
With this command, you specify the primary IPv4 address specified with the VRRP packets
as the source address.
Note
This command is available only with layer 3.
You are in the VRRP Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-if)#
Call up the command with the following parameters:
vrrp <vrid(1-255)> primary-ip <ip_addr>
The parameters have the following meaning:
Value for an IPv4 address
Enter a valid IPv4 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The primary IPv4 address is specified.
You configure a VRRP interface with the interface command.
You remove the primary IPv4 address with the
no vrrp pirmary-ip command.
You show the configuration of the virtual router with the
show vrrp interface - vrid
command.
To Next Page
Loading...
Need help?
General