Siemens SCALANCE XM-400 - No Rmon Event; Commands in the Interface Configuration Mode

Diagnostics
12.5 RMON
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
940 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The event is configured.
Further notes
You delete an entry with the no rmon event command.
You display the RMON Event Table with the
show rmon events command.
You show the details of the SNMP community with the
show snmp community command.
12.5.2.6
no rmon event
Description
With this command, you delete an entry from the RMON event table.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no rmon event <number (1-500)>
The parameter has the following meaning:
Parameter
Description
Range of values / note
number
Number of the event entry to be delet-
ed
1 ... 500
Result
The entry is deleted from the RMON event table.
12.5.3
Commands in the interface configuration mode
This section describes commands that you can call up in the interface configuration mode.
Depending on the Interface selected, various command sets are available.
In the Global configuration mode, enter the
interface command to change to this mode.