Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
517
show ip ospf neighbor
Description
This command shows information about the detected neighboring routers.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show ip ospf neighbor
[{
vlan <vlan-id(1-4094)>|<interface-type><interface-id>
}]
[Neighbor ID]
[detail]
The parameters have the following meaning:
Keyword for a VLAN connection
Number of the addressed VLAN
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
Router ID of the neighbor The ID consists of 4 numbers
each between 0 and 255 and can
match the IP address of the rout-
OSPF information on the neighbor
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
The information on the neighboring routers is displayed.
To Next Page
Loading...
Need help?
General