Configuration
3.1 System
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
63
The system coordinates are displayed.
show device information
Description
This command shows information about the device.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call the command without parameters:
show device information
The information about the device is displayed.
show environmental temperature
Description
This command shows the temperature values of internal and external modules of the device.
The modules are only shown if they make temperature information available.
If the temperature value falls below or exceeds the displayed threshold values, the status
changes accordingly. With the
event config command, you can configure that you are
informed of the status change by a message.
You are in the Privileged EXEC mode.
The command prompt is as follows:
cli#
Call the command without parameters:
show environmental temperature
To Next Page
Loading...
Need help?
General