Siemens SCALANCE XM-400 Configuration Manual

Load control
10.1 Rate control
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
780 Configuration Manual, 06/2016, C79000-G8976-C252-11
10.1.2.5
storm-control level
Description
With this command, you configure the value for the storm control function in Kbps.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
storm-control level <rate-value>
The parameters have the following meaning:
Parameter
Description
Range of values / note
rate-value
Value for the in data rate in Kbps The value range depends on the
port speed. The entry is rounded
down to the next valid value. If
small values are entered, the
value is rounded up to the next
valid value.
Default:
The data rate is set to 0. The
incoming data stream is not lim-
ited.
Result
The value for the storm control function is configured.
Further notes
You can reset the setting to the default with the no storm-control level command.
10.1.2.6
no storm-control level
Description
With this command, you reset the value for the storm control function to the default value.
The default value for the storm control level is 0 Kbps. The incoming data stream is not
limited.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English