Siemens SCALANCE XM-400 Configuration Manual

Network protocols
7.8 SNMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
402 Configuration Manual, 06/2016, C79000-G8976-C252-11
Parameter
Description
Range of values / note
Type
Type of the SNMP notification
•
Trap
generates a trap
• Inform
generates a log entry or sends
an entry to the log server
Storage type specifies whether the settings remain
following a restart:
•
volatile (volatile):
The settings are lost after a
restart
•
nonvolatile (non-volatile):
The settings are retained after
a restart
Result
The details of the SNMP notifications are configured.
Further notes
You delete the details of an SNMP notification with the no snmp notify command.
You display the configured SNMP notifications with the
show snmp notif command.
You display the configured SNMP target addresses with the
show snmp targetaddr
command.
7.8.2.13
no snmp notify
Description
With this command, you delete the details of the SNMP notifications.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp notify <NotifyName>

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English