Siemens SCALANCE XM-400 - Area Range - Ipv6 Prefix;Prefix_Length

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
581
Parameter
Description
Range of values / note
virtual-link
Virtual link
-
router-id
ID of the router Specify the ID in the IPv4 address format
x.x.x.x = 0 ... 255
default-metric
Metric of the standard route
-
range
Address range -
summary
LSA type 3
-
Type7
LSA type 7
-
summary-prefix
Address range of external
routes
-
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the
prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The area is removed or changed.
9.3.3.3
area range - ipv6prefix/prefix_length
Description
With this command, you assign an area ID an address range. The address range is used to
group the routes within OSPFv3.
Note
This co
mmand is available only with layer 3.
Requirement
● The router is an area border router
● You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#