Siemens SCALANCE XM-400 - No Ip Dhcp-Server; Ip Dhcp-Server Icmp-Probe

Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
349
7.5.2.2
no ip dhcp-server
Description
With this command, you disable the DHCP server on the device.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
no ip dhcp-server
Result
The DHCP server is disabled.
Further notes
You enable the DHCP server with the ip dhcp-server command.
7.5.2.3
ip dhcp-server icmp-probe
Description
With this command you enable the function "Probe address with ICMP echo before offer".
The DHCP server checks whether or not the IPv4 address has already been assigned. If no
reply is received, the DHCP server can assign the IPv4 address.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
ip dhcp-server icmp-probe