Siemens SCALANCE XM-400 - No Set Metric; Set Tag

Layer 3 functions
9.8 Route maps (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
731
9.8.3.20
no set metric
Description
With this command, you delete the setting that the metric of the routing information is
changed.
Note
This command is available only with layer 3.
Requirement
You are now in the Route maps configuration mode.
The command prompt is as follows:
cli(config-rmap-$$$)#
Syntax
Call the command without parameter assignment:
no set metric
Result
The metric of the routing information is not changed.
Further notes
You define the setting that the metric of the routing information is changed with the set
metric
command.
You change to the Route maps configuration mode with the command
route-map.
You display the setting and other information with the
show route-map command.
9.8.3.21
set tag
Description
With this command, you specify whether the routing information is forwarded with a changed
tag.
Note
This command is available only with layer 3.