Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
611
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 ospf priority <priority>
The parameter has the following meaning:
Parameter
Description
Range of values / note
priority
Priority 0 ... 255
Default: 1
Result
The priority is specified.
Further notes
You enable OSPFv3 routing with the ipv6 router ospf command.
You reset the priority to the default with the
no ipv6 ospf priority command.
You display the configuration with the
show ipv6 ospf interface command.
9.3.4.12
no ipv6 ospf priority
Description
With this command, you reset the router priority back to the default value.
Note
This command is available only with layer 3.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English