Siemens SCALANCE XM-400 Configuration Manual

Layer 2 management protocols
8.3 IGMP snooping
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
465
The parameter has the following meaning:
Parameter
Description
Range of values / note
switch-ipaddr
Address of the source Specify a valid IP address.
Default: 0.0.0.0
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP address is configured.
8.3.2.6
ip igmp snooping port-purge-interval
Description
The time after which a port is deleted from the list if no IGMP router control packets are
received is known as the purge time.
With this command, you configure this purge time for a port for a VLAN in seconds.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ip igmp snooping port-purge-interval <(130-1225)seconds>
The parameters have the following meaning:
Parameter
Description
Range of values / note
- Value for the purge time in seconds 130 ... 1225
Default: 260
Result
The purge time is configured.
Further notes
You can reset the setting to the default with the no ip igmp snooping port-purge-interval
command.
You can display the status of this function and other information with the
show ip igmp
snooping globals
command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English