Siemens SCALANCE XM-400 - No Mac-Address-Table Static Unicast

Layer 2 management protocols
8.7 Multicast
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
490 Configuration Manual, 06/2016, C79000-G8976-C252-11
8.6.2.2
no mac-address-table static unicast
Description
With this command, you disable the "static unicast" function.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no mac-address-table static unicast <aa:aa:aa:aa:aa:aa> vlan <vlan-id(1-4094)>
The parameters have the following meaning:
Parameter
Description
Range of values / note
aa:aa:aa:aa:aa:aa
MAC address
Specify a valid MAC address.
vlan
Keyword for a VLAN connection
-
vlan-id
Range of values of the VLAN
1 ... 4094
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If you do not select any parameters from the parameter list, the default value is used.
Result
The "static unicast" function is disabled.
Further notes
You activate the setting with the no mac-address-table static unicast command.