Network protocols
7.5 DHCP server
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
362 Configuration Manual, 06/2016, C79000-G8976-C252-11
You cancel the assignment with the no relay-information command.
You display the setting with the
show ip dhcp relay information command.
You enable the IPv4 address band with the
pool-enable command.
no relay-information
Description
With this command you cancel the assignment of devices with a certain remote ID and circuit
ID to IPv4 addresses from a specific address band.
You are in the DHCPPOOL configuration mode.
The command prompt is as follows:
cli(config-dhcp-pool-<ID>)#
Call up the command with the following parameters:
no relay-information <remote-id> <circuit-id>
The parameters have the following meaning:
Remote ID of the device Enter the remote ID of the de-
Circuit ID of the device. Enter the circuit ID of the de-
The assignment is canceled.
With the relay-information command, you assign devices with a certain remote ID and
circuit IPv4 addresses from a specific address band.
You display the setting with the
show ip dhcp relay information command.
You enable the IPv4 address band with the
pool-enable command.
To Next Page
Loading...
