Siemens SCALANCE XM-400 - No Summary-Address

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
550 Configuration Manual, 06/2016, C79000-G8976-C252-11
Result
The address range is created.
Further notes
You delete the address range with the no summary-address command.
You can display the status of this function and other information with the
show ip ospf -
area-range / summary-address
command
9.2.3.27
no summary-address
Description
With this command, you delete the address range.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
no summary-address <Network> <Mask> <AreaId>
The parameters have the following meaning:
Parameter
Description
Range of values / note
Network
IP address of the address range
specify the IP address
Mask
Subnet mask of the address range
specify the subnet mask.
AreaId
Area-ID specify a valid ID.
x.x.x.x
x = 255
0.0.0.0 = backbone area
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".