Siemens SCALANCE XM-400 - Show Spanning-Tree Mst; Show Spanning-Tree Mst Configuration

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
239
6.3.1.7
show spanning-tree mst
Description
This command shows various settings of the spanning tree configuration specific to a
Common Internal Spanning Tree (CIST) instance or a selected instance of the Multiple
Spanning Tree Protocol.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with one of the following parameter assignments:
show spanning-tree mst[<instance-id(1-64|4094)>][detail]
The parameters have the following meaning:
Parameter
Description
Range of values / note
instance-id
Number of the instance or range of
instances whose settings are displayed
• 1 ... 64
• 4094
detail
Shows detailed information about the
selected interface
-
Result
The settings for the spanning tree configuration are displayed.
Further notes
You display the general settings for the Spanning Tree Protocol with the show spanning-tree
command.
6.3.1.8
show spanning-tree mst configuration
Description
This command shows various settings for an instance of the Multiple Spanning Tree
Protocol.