Siemens SCALANCE XM-400 - Ipv6 Enable

Network protocols
7.2 IPv6 protocol
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
326 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call up the command with the following parameters:
no ipv6 address <prefix> link-local
The parameter has the following meaning:
Parameter
Description
Range of values / note
prefix
Link local address Specify a valid link local address.
fe80::xxxx:xxxx:xxxx:xxxx
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The link local address is deleted.
Further notes
You assign a link local address to an interface with the ipv6 address link-local command.
You display this setting and other information with the
show ipv6 interface command.
7.2.4.8
ipv6 enable
Description
With this command, you enable IPv6 on the interface. As default, IPv6 is disabled.
Requirement
● IPv6 routing is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Requirement
You are in the Interface configuration mode of VLAN.
The command prompt is as follows:
cli(config-if-vlan-$$$)#