Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.6 Management Access Control List
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
861
Result
The information about the configuration of the authorized managers is displayed.
11.6.2
Commands in the Global configuration mode
This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the
configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can
be found in the relevant sections.
You exit the Global configuration mode with the
end or exit command and are then in the
Privileged EXEC mode again.
11.6.2.1
authorized-manager
Description
With this command, you enable the authorized manager.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
authorized-manager
Result
The authorized manager is activated.
Further notes
You disable the function with the no authorized-manager command.
11.6.2.2
no authorized-manager
Description
With this command, you disable the authorized manager.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English