Siemens SCALANCE XM-400 - No Vrrp Vrid-Track; Commands in the Interface Configuration Mode

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
630 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.4.3.10
no vrrp vrid-track
Description
With this command, you disable VRID tracking.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP Router configuration mode.
The command prompt is as follows:
cli(config-vrrp)#
Syntax
Call the command without parameter assignment:
no vrrp vrid-track
Result
VRID tracking is disabled.
Further notes
You enable VRID tracking with the vrrp vrid-track command.
You display configured VRID trackings with the command
show vrrp interface or show vrrp
interface - vrid
with the parameter detail.
9.4.4
Commands in the Interface Configuration mode
This section describes commands that you can call up in the Interface configuration mode.
● The commands are only available with layer 3
● Enable routing to use VRRP.
● You can only use VRRP in conjunction with VLAN interfaces.
● VRRP only supports IPv4. If you want to use IPv4 and IPv6, use VRRPv3