Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
536 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call the command without parameters:
compatible rfc1583
Result
The compatibility with RFC 1583 is disabled.
Further notes
You enable the compatibility with the compatible rfc1583 command.
You can display the status of this function and other information with the
show ip
ospf
command.
9.2.3.13
default-information originate
Description
With this command, you enable the function with which a standard route is generated for
external routes into the OSPF routing domain.
Note
This command is available only with layer 3.
Requirement
You are in the OSPF Router configuration mode.
The command prompt is as follows:
cli(config-ospf)#
Syntax
Call up the command with the following parameters:
default-information originate [(
[always]
[metric <metric-value (0-0xffffff)>]
[metric-type <type (1-2)>])]

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English