Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.4 VRRPv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
642 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.4.4.12
vrrp timer
Description
With this command, you specify the time interval after which a virtual router with the "Master"
status sends an advertisement packet again.
Note
This command is available only with layer 3.
Requirement
● An IPv4 address is assigned to the virtual router.
● You are in the VRRP Interface configuration mode
.The command prompt is:
cli(config-vrrp-if)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> timer <interval(1-255)secs>
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
interval
Time interval in seconds 1 ... 255
Default: 1 s
Result
The time interval is specified
Further notes
You configure a VRRP interface with the interface command.
You enable routing with VRRP with the
router vrrp command.
You reset the time interval to the default with the
no vrrp timer command.
You assign IP addresses to a virtual router with the
vrrp associated-ip command.
You show the interval with the
show vrrp interface - vrid command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English