EasyManuals Logo

Siemens SCALANCE XM-400 Configuration Manual

Siemens SCALANCE XM-400
960 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #598 background imageLoading...
Page #598 background image
Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
598 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.3.3.17
no redist-config
Description
With this command, you delete the information for the new external routes.
Note
This command is available only with layer 3.
Requirement
The router is an ASBR router.
You are in the OSPFv3 router configuration mode.
The command prompt is as follows:
cli(config-ospfv3)#
Syntax
Call up the command with the following parameters:
no redist-config <IPv6-Prefix> <Prefix-Length>
The parameters have the following meaning:
Parameter
Description
Range of values / note
IPv6-Prefix
IPv6 address
Enter a valid IPv6 address
Prefix-Length
Number of bits belonging to the prefix
(from left to right)
1 ... 128 bits
128: The node (host) itself
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The information for the route is deleted.
Further notes
You enable the ASBR router with the ASBR Router command.
You create the information with the
redist-config command.
You display the setting with the
show ipv6 ospf command.

Table of Contents

Other manuals for Siemens SCALANCE XM-400

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SCALANCE XM-400 and is the answer not in the manual?

Siemens SCALANCE XM-400 Specifications

General IconGeneral
BrandSiemens
ModelSCALANCE XM-400
CategorySwitch
LanguageEnglish

Related product manuals