Siemens SCALANCE XM-400 - Switchport Mode Private Vlan

Network structures
6.1 VLAN
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
209
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameters:
no switchport mode
Result
The setting is reset to the default value.
Further notes
You configure the operating mode with the switchport mode command.
You display this setting and other information with the
show vlan port config command.
You configure the interface as a switch port with the
switchport command.
6.1.3.13
switchport mode private vlan
Description
With this command, you specify the operating mode for the private VLAN port.
Requirement
● The interface is configured as a switch port.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
switchport mode private-vlan {promiscuous | host}