Siemens SCALANCE XM-400 - Ipv6 Rip Default-Information Originate; No Ipv6 Rip Default-Information

Layer 3 functions
9.7 RIPng (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
705
9.7.4.1
ipv6 rip default-information originate
Description
With this command you enable the function that an IPv6 standard route is generated in the
IPv6 routing table via this interface for routes from the local RIP database.
Note
This command is available only with layer 3.
Requirement
● The interface is an IPv6 interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
ipv6 rip default-information originate
Result
The function is enabled.
Further notes
You disable the function with the no ipv6 rip default-information originate command.
You display the IPv6 routing table with the
show ipv6 route command.
9.7.4.2
no ipv6 rip default-information
Description
With this command you disable the function that a standard route is generated in the IPv6
routing table for routes from the local RIP database.
Note
This command is available only with layer 3.