Siemens SCALANCE XM-400 Configuration Manual

Layer 3 functions
9.5 VRRPv3 (IPv4 / IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
662 Configuration Manual, 06/2016, C79000-G8976-C252-11
9.5.5.3
vrrp associated-ip
Description
With this command, you specify which IP addresses the virtual router monitors.
Note
This command is available only with layer 3.
Requirement
You are in the VRRP3 Interface configuration mode.
The command prompt is as follows:
cli(config-vrrp-v3-if-$$$)#
Syntax
Call up the command with the following parameters:
vrrp <vrid(1-255)> associated-ip [{ ipv4 <ip_addr> | ipv6 <ip6_addr> }]
The parameters have the following meaning:
Parameter
Description
Range of values / note
vrid
ID of the virtual router
1 ... 255
ipv4
Keyword for IPv4 address
-
ip_addr
IPv4 address
Enter a valid IPv4 address.
ipv6
Keyword for IPv6 address
-
ip6_addr
IPv6 address
Enter a valid IPv6 address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Result
The IP addresses are specified.
Further notes
You can create a maximum of 52 virtual IPv4/IPv6 addresses.
You configure a VRRP3 interface with the
interface command.
You remove an IP address with the
no vrrp associated-ip command.
You display the IP addresses with the
show vrrp3 command.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English