Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
829
Syntax
Call up the command with the following parameters:
no mac access-group <access-list-number(1-128)>{in|out}
The parameters have the following meaning:
Parameter
Description
Range of values / note
access-list-number
Number of the access control list
1 ... 128
in
Specifies that incoming packets are
filtered
-
out
Specifies that outgoing packets are
filtered
-
Result
The packet filtering according to the access control list (ACL) is canceled.
Further notes
You enable the setting with the mac access-group command.
You display the configuration of the access control list with the
show access-lists command.
11.3.4
Commands in the MAC ACL configuration mode
This section describes commands that you can call up in the MAC ACL configuration mode.
In the Global configuration mode, enter the
mac access-list extended command to change
to this mode.
● If you exit the MAC ACL configuration mode with the
exit command, you return to the
Global configuration mode.
● If you exit the MAC ACL configuration mode with the
end command, you return to the
Privileged EXEC mode.
11.3.4.1
permit
Description
With this command, you configure a MAC address control list that describes the MAC
addresses for which incoming and/or outgoing data traffic is permitted.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English