Siemens SCALANCE XM-400 Configuration Manual

Security and authentication
11.3 MAC access control list
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
830 Configuration Manual, 06/2016, C79000-G8976-C252-11
The access control list contains only one entry. If you want to lock or permit further
addresses, create a new access control list.
Note
Processing order of the lists
The access control lists are processed on the interface in the order in which they were
created.
The index number of the access control list is not used for this.
Requirement
You are in the MAC ACL configuration mode.
The command prompt is as follows:
cli(config-ext-macl)#
Syntax
Call up the command with the following parameters:
permit {any|host<src-mac-address>}{any|host<dest-mac-address>}
The parameters have the following meaning:
Parameter
Description
Range of values / note
any
Keyword for "all"
-
host
Keyword for the MAC address of an
incoming connection that is permitted
-
src-mac-address
MAC address of the permitted incom-
ing connection
Specify a valid MAC address.
any
Keyword for "all"
-
host
Keyword for the MAC address of an
outgoing connection that is permitted
-
dest-mac-address
MAC address of the permitted outgoing
connection
Specify a valid MAC address.
For information on names of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
Note
MAC address input
Use "any", if the rule is to apply to all src and/or dest MAC a
ddresses. This corresponds to
the MAC address "00:00:00:00:00:00".

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English