Siemens SCALANCE XM-400 - Ip Ospf Priority

Layer 3 functions
9.2 OSPFv2 (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
564 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if-$$$)#
Syntax
Call the command without parameter assignment:
no ip ospf transmit-delay
Result
The interval is deleted.
Further notes
You configure the interval with the ip ospf transmit-delay command.
9.2.4.17
ip ospf priority
Description
With this command, you specify the router priority. The designated router is identified based
on the priority.
Note
This command is available only with layer
3.
Requirement
● The interface is an IPv4 interface.
● You are in the Interface configuration mode.
The command prompt is:
cli(config-if)#
Syntax
Call up the command with the following parameters:
ip ospf priority <value (0 - 255)>