Siemens SCALANCE XM-400 - Show Ipv6 Ospf

Layer 3 functions
9.3 OSPFv3 (IPv6)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
568 Configuration Manual, 06/2016, C79000-G8976-C252-11
Syntax
Call the command without parameters:
show ipv6 ospf
Result
The configuration is displayed.
9.3.1.2
show ipv6 ospf ... database ...
Description
This command shows information about a specific LSA type or all LSA types.
Note
This command is available only with layer 3.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show ipv6 ospf
[area <AreaID>]
database
[ {
router|network|as-external|inter-prefix|inter-router|intra-
prefix|link|nssa
} ]
[{
detail|HEX
}]