Siemens SCALANCE XM-400 - No Ring-Redundancy

Layer 2 management protocols
8.5 Ring redundancy and standby connection
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
Configuration Manual, 06/2016, C79000-G8976-C252-11
477
The parameters have the following meaning:
Parameter
Description
ard
Enables the automatic redundancy mode (Automatic Redundancy Detec-
tion)
mrpauto
Enables the automatic MRP manager
mrpclient
Enables ring redundancy with the MRP protocol as client
hrpclient
Enables ring redundancy with the HRP protocol as client
hrpmanager
Enables ring redundancy with the HRP protocol in ring redundancy manag-
er mode
Result
The ring redundancy function is enabled and the redundancy mode is selected.
Further notes
You disable the ring redundancy function with the no ring-redundancy command.
8.5.5.5
no ring-redundancy
Description
With this command, you disable the ring redundancy function on a device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no ring-redundancy
Result
The ring redundancy function is disabled.
Further notes
You enable the ring redundancy function with the ring-redundancy mode command.