Siemens SCALANCE XM-400 - No Service Dhcp-Relay

Network protocols
7.6 DHCPv4 Relay Agent (IPv4)
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
372 Configuration Manual, 06/2016, C79000-G8976-C252-11
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameter assignment:
service dhcp-relay
Result
The DHCP Relay Agent is activated.
Further notes
You disable the DHCP Relay Agent with the no service dhcp-relay command.
You create the IP addresses of the DHCP server with the
ip dhcp server command.
You can display the status of this function and other information with the
show ip dhcp relay
information
command.
7.6.2.7
no service dhcp-relay
Description
This command disables the DHCP relay agent.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
no service dhcp-relay
Result
The DHCP Relay Agent is disabled.