Diagnostics
12.2 FMP
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
906 Configuration Manual, 06/2016, C79000-G8976-C252-11
The parameters have the following meaning:
Keyword for a an interface description
Type or speed of the interface Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
The limits set for the received power and the power loss are displayed.
show fmp status
Description
This command shows the current status and the current values of the optical ports or
connections that you monitor with fiber monitoring.
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Call up the command with the following parameters:
show fmp status [{interface <interface-type> <interface-id>}]
The parameters have the following meaning:
Keyword for a an interface description -
Type or speed of the interface
Enter a valid interface.
Module no. and port no. of the interface
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 42)".
If no parameters are specified, the settings for all interfaces are displayed.
To Next Page
Loading...
Need help?
General