Siemens SCALANCE XM-400 Configuration Manual

Network structures
6.3 Spanning Tree
SCALANCE XM-400/XR-500 Command Line Interface (CLI)
274 Configuration Manual, 06/2016, C79000-G8976-C252-11
Further notes
You can reset the settings to the default values with the no spanning-tree mst
pseudoRootId
command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.
6.3.5.21
no spanning-tree mst PseudoRootId
Description
With this command, you reset a pseudoroot MAC address and the priority of the spanning
tree configuration to the default values.
The default values are as follows:
● The priority is configured to the priority of the device.
● The MAC address is configured to the MAC address of the device.
Requirement
You are in the Interface configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
no spanning-tree[mst<instance-id(1-64)>]pseudoRootId
The parameters have the following meaning:
Parameter
Description
Range of values / note
mst
Keyword for a spanning tree instance
-
instance-id
Number of the instance
1 ... 64
Result
The pseudoroot MAC address and the priority are rest to the defaults.
Further notes
You configure the settings with the spanning-tree mst pseudoRootId command.
You display this setting and other information with the commands that start with
show
spanning tree ...
.

Siemens SCALANCE XM-400 Specifications

General

Brand	Siemens
Model	SCALANCE XM-400
Category	Switch
Language	English